Here are those pics of the helmet with that weird Bondo stuff. Unfortunately, I'm new to it, so some parts will have to be redone because there wasn't enough hardening gel put in it so it's permanently sticky. Other than that, it looks super ugly, but it's coming along nicely. Also, just recently I discovered a problem with my schematic in the sense that there isn't enough width on the case to put both drive bays side by side. If anyone could give me some tips on how I could make it work I would be delighted; even if you don't have any sollutions, please leave a message on this thread, it's getting lonely being the only one posting. Well, I'm going to go cry lol, so I'm out.
*Note the yellow quesadilla maker in the background. That thing kicks major nalgas!*
Re: Project PC In Disguise
Sure most of them are probably from me lol, but thanks for those of you that read this read and submit posts on this thread. Once I figure out a solution to the little slider dilemma, this project should be progressing super fast. Today, I hope to put on the final layer of bondo to the top part of the helmet, and start planning out the bottom half, but until then, I'm out. Once again thank you to everyone, and don't forget to keep actually POSTING comments and whatever on this thread.
Reply With Quote
Originally Posted by jdbnsn
What's that? Does it look like the helmet's broken? It sure does. I happen to have a phobia of wasps and with the weather being the way it is in The 'Peg this year, there are nothin but those pissed off bees flying around. Short story even shorter, I got chased by one and well, I dropped the helmet. It turned out to be a blessing in disguise because it gives me a reason for having such a roughed up helmet. As I had said before to Drakena (my g/f), the new paint scheme for the project is going to be a roughed up, a$$-kicked Optimus. Now it (hopefully) won't look like a crappy sanding job but rather a battle torn case. Well until I get better and I start painting it, I'm out.
