Re: Project: L3p L4n
Apparently my friend Quepee has some trouble finding the right piece of copper for the MarsII block. So me and an other guy started looking for it too, but till now no success yet.
It need to be 155x300x15,5 mm (Copper Cu-ETP?)
If anyone has some tips? Please!
And here a 'small' update.
I want to try this DP to VGA converter to use the touchscreen.
I already adjusted the bracket once but I'll have to do it again because the MarsII is 6cm longer then the Matrix card. Also want to mount the Pump controller print on top of it.
Measuring.
Dremeling.
Filing.
Drilling some holes.
Seems to fit.
So painting it again.
Will be quite some cable management.
Also need to do the lighting before I start with the watercooling loop cause of all the wires.
Going to use this controller instead.
It's a Touch remote with RF, so don't have to place any IR eyes
Ik ga dus deze controller gebruiken ipv de vorige.
(Will also be used in my next project)
Glad I still had an old black floppy cable.
Nice afternoon soldering with my daughter.
She told me to test it before cutting it in pieces.
Glad I did, found a break!
Can cut that out now.
Epoxy layer is easy to remove with a knife.
Hmm my gas-soldering iron is too hot for this.
So got an other one a few days later.
Getting too much work on my neck
Almost done.
Used some 4-pin PWM plugs to easy-connect it all.
And some tests.
Lets do the bottom too. First had to remove some stickers and old glue.
And done.
Some connectors for the bottom.
And testing again.
My 'simple' compact camera doesn't show what I see so tried to film it instead
Till the next update!
Reply With Quote
Originally Posted by SXRguyinMA
