Chiller's Level10 hybrid cooled

[Chiller]

today i customized the 3D fangrill so it fits on my Coolit Boreas Chiller :

This was how it looks standard :

And after the adjustment, who see the difference ???? lol :tong:

And this is how it going to fit in black and red on the Chiller :

[x88x]

Nicely done. Very clean conversion.

[Chiller]

thanks

[SXRguyinMA]

looks factory

[Chiller]

factory ? lol, that's a good one, didn't hear that before.

thanks for compliment

[TheGreatSatan]

Yeah, like it so cleanly done that it looks fresh from the factory.

At least that's what he means

[Chiller]

i need to adjust the motherboard case a little that the SR-2 will fit in.

[AnG3L]

Amazing mod man nothing else to say!

[slaveofconvention]

No offence meant, I swear, it does look very VERY well done but... (ya knew there was a but coming, right?) that fan grille looks like it's going to block a huge amount of the potential airflow going through that fan. You could get around that problem (clearance allowing) by placing spacers between the fan and grille so air can get in (or out) from the sides too though...

Again, it looks downright awesome, I'm just a sucker for practicality lol

[Chiller]

Actually, it's not a bad idea to give the fan some more room to blow yes.
I take the dremel lol

MAt Black acryl bended with a heatgun, for detail for the Boreas chiller on the HDD bays.

now waiting to receive the mobo hopefully this week, or at last beginning next week.
Also a nice toy for OC, the Evga EVbot.

The motherboard (hopefully this week)

Mobo SR-2 link info

Nice toy for OC on the mobo :

EVbot link info

Only problem is that the case needs a big adjustment for fitting the mobo in the case,
but it will work how i whant it.

i can also use a backplate likes this, but i will keep the original backplate of mobo, but adjust it :

If you look at the sizes of the Classified ATX mobo (30.5 x 26.4cm) against a SR-2 E-ATX (34.6 x 38cm) :

the case will need some adjustments lol.