Went out this evening more then prepared to set the engine in...So I thought. After looking through all of the bolts given to me with the 3-wheeler, it turns out none go with it. Or at least, none hold the engine in... On top of that, these two plates that hold the front of the engine are missing...
So, instead of working, I grabbed a caliper, tape measure, and pen. Using these fancy measuring tools, I figured up with the required length, and size of the bolts for the engine. Simple. When figuring out length, you need to make sure to compensate for the part, mounting tabs, nut, and any washers you are using. More is better then less... Size I figured out by measuring with a caliper in thousandths, then converting to metric. Wasn't hard to figure out what size I needed then.
For my tool guys, I picked up a couple new toys at HF. The Sensor/Injector socket set, and a 3lb Dead Blow.
Really wanted the socket set for sensor sockets.
http://www.harborfreight.com/oxygen-...set-99850.html
Heard good things, and the only dead blow I have is a cast steel one... Figured out if you pop these little caps off at the end of the handle, there is a hole through the core. Good for hanging!
http://www.harborfreight.com/3-lb-ne...mer-41799.html