Shot with the WBs and all their children.
Cleaned up the VC with ...
Put it together ...
One down, one to go.
Shot with the WBs and all their children.
Cleaned up the VC with ...
Put it together ...
One down, one to go.
Ok, does that look a little christmasieish? Why can't we order the boards in the colors we want.
shoulda waited a month on it....then it woulda been perfect timing
lookin great mdcs.....ive been watchin this since it started....love all the work youve done
Yeah, i think im going to try the drop cloth tent idea you gave me, except with some plastic wrap you use for painting. And once again, your water blocks look sexy as hell... lol
You're asking, what's going on? Why are the GPU WBs already set up?
Because ... I'm going for a short hose set up like the last one, and it will be
installed right in the case. I'm using mct-40, and I'm good at covering the
parts just in case during the testing.
Both ...
And the only solution I can come up with that will actually have the fan
(remember, there will be a 120mm in front of the Xchanger) useful for the
Xchanger, and not crimp the hose. The res, pump, rad, & xchanger all all set
up.
The rest will be easy. The one rad output to the CPU WB, up to the 1st GPU,
right down to the next GPU and back to the input on the res.
So, the way it looks though is iffy too me. I've tried lots of ways. And if it
looks too crowded and just funky. I'm going to ditch the Xchanger.
And, even though I was going to go 1/2", everything is 3/8". With the WB's and the res bottlenecks, it looks easier to just go 3/8". So, I just reduced the pump, and different fittings on the rad.
When did you buy the EVGA 7900GT video cards and how much did you pay for them? Because if it has been less than 90 days, you could use their Step-Up Program and get a better video card. If you want, you could get the 8800GTX (I think one of those beats 2 7900GTXs in SLI on most occasions). I'll have to check the benchmarks again.
Mobo & CPU ...
This is why I do so many dry runs on everything ...
It just won't work where the pump is now. It's in the way of the second VC.
I'm going to have to ditch the Xchanger, and put the pump somewhere else.
This case is way too small. Smallest I've worked on.
Something has to work. Any ideas
I don't know. I may have to put the pump where the rad is, and put the rad on the outside. I really wanted it all inside. Maybe on the inside back. I'll try that
too. Then the outside back. I could move to the smaller Swifttech pump again (oh boy, re-painting). I'll try what I can first.
can't you just put the pump closer to the rad (not in front of it) when you ditch that xchanger?? and maybe turn the pump 90 degrees, so that the tube from the res-thingie goes into the pump straight. Also I don't think it would be really bad if the pump is a few cm in front of the rad... but I'm no WaterCooling-expert.
hope you can work this out in the case... Would be a shame to put the rad on the slick looking outside...