So last night at Midnight I saw Iron Man 2!
I am going to finish this thing already. Time to make a chain gun! I'm going to use this cheap plastic piping that I'm cutting with a regular hand saw
Into six pieces
This is how it's going to look. The center will have a shorter version of the same pipe
For now rubber bands will hold it together
The base of the gun will be an old hollowed out PSU
I have this cool mesh from my Project: Framed
I'll be covering the sides with it
Now I measure out the hole for the pipes
The hole saw I have is a little big, but will be addressed afterwards
Here it is cut out
And when set on the case
Before I actually mount it, I must get to the painting