At this stage the paper can now be removed to show the matching silver floor.
Next was to install the motherboard cover, as you can see ive cheeted and added a few new extra's to it with out posting i thought adding active cooling would look "cooler" then the mesh grill and added a lil flame grill with a accent around the CPU tube hole.
After a few new mounting holes are drilled to the floor and pump mounts i can actually move onto the plumbing (always my fav part)
I love a plumbing challange! and wanted to try and come up with a new design for the water tubes!
The rad is a tight fit! and i usually fit them externally! but wanted the challenge of making everthing fit inside this mod
The Good old NOS res is mounted and installed.
All hoses are tie clamped!
The pump was a tight fit! and i may swap it over for a MPC-350.
I like this LOOP! the coil effect works in well and stil has a clean flowing look to it.