Hey guys, I'm installing an amp in my car and i ordered a kit w/ all the wires to wire everything up. I was looking at the terminals and i wasn't sure if i had the right tools to crimp them on to the wires.
I have a number of ring and spade terminals that seem similar to this
Is this the right tool to crimp those to my wires?
I have one of those and i did a test w/ some extra connectors on to some speaker wire. It seems mostly solid but i wanted to make sure i was doing it right.
I just sorta squished the round end down flat on to the bare wire using the crimp tool above.
Is that right?
I know, this is a really stupid question.
Thanks guys