"T-Eng" - Lian Li PC-A05NB - by Ikem

[SXRguyinMA]

indeed it does!

[ikem]

starting to mock up the hardware, and start positioning things.

so i started modding the psu for the clean look that i want. I have shortened the cables significantly. fitting everything behind the psu. this psu will only work with this case now. haha

now once i sleeve the cables that are running along the front 120mm fan, the cable will be done. also i have to get some thinner wire for the led power. it look so clean!

any comments?

[msmrx57]

Looking good. Cable management is very clean. My only suggestion would be get some plastic paint for the toolless clips, they stand out a bit much.

[BS Mods]

You don't see orange everyday but it looks really cool. I like it so far. Nice work on cabling too.

[ikem]

i may be getting some modders mesh and use it to cover the mobo in some kind of orange. ive seen it done with sheet aluminum also.

and tomorrow im getting it photographed by a lot better camera. since this camera is horrible quality.

here is the concept of the front bezel. it doesnt restrict airflow at the moment.

and the Grills and feet have arrived from MNPCTech.com! Thanks Bill.

140mm Computer Billet Fan Grills

Grooved Machined Aluminum Case Feet

the 140mm fans are just sitting up there for reference right now.

[x88x]

Nice. Those MNPCTech billeted grills are awesome....ridiculously expensive, but awesome.

[ikem]

Here is the pic of the end of the week. Once I order the rusting paint, I will continue with modding.

[billygoat333]

Nice. Those MNPCTech billeted grills are awesome....ridiculously expensive, but awesome.

this. bad freakin a man.

[ikem]

Finished the side window today.

16" x 11 1/4" x 1/4" lexan for the window

10x 10-24 x 5/8" hex head bolts
10x Brass Washers
10x 10/24 Hex Nuts