background connections question

[BuzzKillington]

So I came across these instructions on logging internet connections running in the background.

* Type cmd in your Windows Run box.
* Type "netstat -b 5 > activity.txt" and press enter.
* After say 2 minutes, press Ctrl+C.
* Type "activity.txt" on the command line to open the log file in notepad (or your default text editor)

I came up with about 20 results. Even stumble upon was running when I had nothing opened.

[TheGreatSatan]

Maybe do a print screen so we could see?

[x88x]

If you post the contents of that file, I might be able to tell you what's going on. OOC, where did you get those instructions? As far as I know throwing a '5' after the '-b' won't do anything. It won't break anything, but it won't do anything either. Here's the netstat help output:

C:\Users\x88x>netstat -h

Displays protocol statistics and current TCP/IP network connections.

NETSTAT [-a] [-b] [-e] [-f] [-n] [-o] [-p proto] [-r] [-s] [-t] [interval]

  -a            Displays all connections and listening ports.
  -b            Displays the executable involved in creating each connection or
                listening port. In some cases well-known executables host
                multiple independent components, and in these cases the
                sequence of components involved in creating the connection
                or listening port is displayed. In this case the executable
                name is in [] at the bottom, on top is the component it called,
                and so forth until TCP/IP was reached. Note that this option
                can be time-consuming and will fail unless you have sufficient
                permissions.
  -e            Displays Ethernet statistics. This may be combined with the -s
                option.
  -f            Displays Fully Qualified Domain Names (FQDN) for foreign
                addresses.
  -n            Displays addresses and port numbers in numerical form.
  -o            Displays the owning process ID associated with each connection.
  -p proto      Shows connections for the protocol specified by proto; proto
                may be any of: TCP, UDP, TCPv6, or UDPv6.  If used with the -s
                option to display per-protocol statistics, proto may be any of:
                IP, IPv6, ICMP, ICMPv6, TCP, TCPv6, UDP, or UDPv6.
  -r            Displays the routing table.
  -s            Displays per-protocol statistics.  By default, statistics are
                shown for IP, IPv6, ICMP, ICMPv6, TCP, TCPv6, UDP, and UDPv6;
                the -p option may be used to specify a subset of the default.
  -t            Displays the current connection offload state.
  interval      Redisplays selected statistics, pausing interval seconds
                between each display.  Press CTRL+C to stop redisplaying
                statistics.  If omitted, netstat will print the current
                configuration information once.