Fallout 2.1

[Cheron]

yes indeed Its a tight fit.. I will relocate the top Reservoir clamp to a bit higher point to make the installation a bit easier.

[Cheron]

Ok this is what i am going to do today..... as you can see I tore it down to the bone..

I am going to clean the glue from the top where the Bottle caps used to be....
So I have room to draw some Air vents....
don't worry ill keep that Bottle cap reference to Fallout in. but more subtle this time.

And Also Ill start cutting the back for the fan is showed earlier.

Ill be back later today to show results. I really want to get this done.
yours Cheron.

[The boy 4rm oz]

A good start mate. That rear fan will help a lot for airflow. Have you even thought of mounting the res on the top of the case over the fans you will be installing there?

[Cheron]

yes I have thought of mounting the Res on top. but since it isn't in the way (and doesn't block airflow being rounded as it is) ill keep it on the back.

For the vents on the top there wont be Fans just openings with some mesh..

Like your Lexa the Air intake will be primary from below trough the Radiator. also there will be air moving in from the front where the old Radiator used to be.

So that brings us to 3X 120 mm intake fans and just 2 (one being the PSU fan) exit fans. with this in mind ill just vent the execs air trough the top.(with out a Fan. hot air will raise any way)

I have a new picture.

yours Cheron.

[The boy 4rm oz]

All taken apart, nice. Now the fun begins lol.

[DonT-FeaR]

cool this is the good part...

[Cheron]

Just Letting you all know Fallout 3 (the game) is coming to stores near you 28 Oct.(US) and 31 Oct. (EU).

So there is my dead line.....

[The boy 4rm oz]

Yep saw that on Tech Power Up today after school. That leaves you just over 2 months to get this all done.

[Cheron]

Ok I have some Pictures.

The vents in the top panel. there will be mesh in those holes.

Two extra holes in the back. both will be covered from within, with some mesh.

I also cut the hole for the 240 radiator. as you can see here, I primed it with the base coat.

here you can see the MB tray all painted satin black.

That is all I can show you today. for now I cant go on have to wait for parts.
But I'll be fabricating some smaller parts in the coming days.

Yours Cheron.

[The boy 4rm oz]

Coming together (back together I should say) nicely.