Case mod's

[xmastree]

If you have a drill you can puch a series of holes side by side but then you'd have a ton of filing to do after ward.

Not necessarily a ton of filing. It depends on what you plan to do with the hole...
http://www.thebestcasescenario.com/f...0&postcount=27
I simply placed the grille where I wanted it and drew round it on the sheet of self adhesive paper I stuck on there first. Then, when drilling, just make sure that the outer edge of the hole is between the lines and the only filing involved is to remove the sharp edges. That one was a bit rough on the left side due to hitting one of those vents.
I deliberately chose those grilles so that I could leave a less than perfect edge and still get away with it.

[coleman17]

thanks for the quick replies, im going to start out with the hole saw for the drill to make my blowhole , its quite expensive at home depot as i remember so if i could have a link to one online? it would be very nice. Then if i have enough money i will plan out my window , its probably going to be quite large and im sttrapped for funds right now so it may take a while.Thanks again

[coleman17]

http://www.mnpctech.com/DremelDisc.html
^^^^would that work for what i want to do??

[Aero]

yep, thats the reinforced cutting disk I was talking about.

[Cevinzol]

http://www.harborfreight.com/ enter key word "hole saw" not sure what size you plan on so I can't link a suggestion.

[coleman17]

Ok, thanks i will order the discs today, as for the blowhole im thinking of making it larger than just the fan so i will also use the dremel with it, thanks and i will post some pics when im done.