My First Case MOD!!!

[7angofragger]

Just before we starting sanding em down

[7angofragger]

Almost done sanding

[7angofragger]

Just got done cuttin and drillin

How it looks, looking straight on the side

An away side view

An angled profile shot...

Now all we have to do is sand down the entire side panel and start on the bottom of the case!

[7angofragger]

The test fan screwed up perfectly!!! Now for the bottom of the case!

[SabreNoose]

i can forsee an issue you may have with those fans, as they are so close together, you may find that they will not be able to fit in the way you have designed due to the "lip" around the outside. i hope it goes well.

[7angofragger]

we have already took in account for that and we have fit 4 regular black fans in there and slid the side panel in... only thing i we will have to cut to make the side panel fit is just a little notch out of the bottom 2 5.25 bays... but that will be fine because the Aerocool gatewatch 2 that i am going to buy will take up the bottom 2 5.25 bays. the gatewatch's depth is only about 2.5", so it will work out fine...

[7angofragger]

Here we had to make room to fit the top right 120mm side panel fan. This will not affect the mounting of the AeroGate sensor.

Here is the hole in the bottom of the case... The plan just changed when we found some spare plexiglass... We are going to mount a section of plexiglass on the bottom of the case, and then mount the 120mm on top, allowing more light to shine under the case, giving it an underglow affect

Here is how it should look..... should....

A closer view of the bottom of the case

[7angofragger]

Cuttin the hole in the plexi for the 120mm fan

Holes cut, and fan mounted!

How it will look in the bottom of the case

A closer shot....

[Eclecticos]

You may want to make a Frame for the four fans, and fill in the Hand Grip.
Looks Good so Far!

[m0h3k4n]

Thougt something like this might look good, where you cut away the thin stuff and attach all four fans in the center with the floating piece.