The project which I started to do about ten months ago now is completed. And I am looking forward to hearing your opinion about it. It is only my mouse mod 3.
I am the administrator of the site www.modding.ru
1.My mouse mod was based on Microsoft IntelliMouse Optical, USB+PS/2
2 More than 90 per cent of plastic was cut out.
http://i133.photobucket.com/albums/q...DSC00942-2.jpg
3 All the details ( including the wheel of scrolling and the buttons) were cast from the stainless steel 18/10 (which is used for medical instruments)Some decorations were cast and soldered.
http://i133.photobucket.com/albums/q...DSC01013-4.jpg
http://i133.photobucket.com/albums/q...DSC01019-4.jpg
http://i133.photobucket.com/albums/q...DSC01106-6.jpg
http://i133.photobucket.com/albums/q...SC01208-10.jpg
http://i133.photobucket.com/albums/q...SC01365-13.jpg
http://i133.photobucket.com/albums/q...SC01499-16.jpg
http://i133.photobucket.com/albums/q...SC01515-17.jpg
The mouse mod was decorated by Svarovsky stresses.
The connector USB was cast from the stainless steel too.
The wire is inside the steel casing.
http://i133.photobucket.com/albums/q...SC01735-24.jpg
I made a special case of glassy plastic for this mouse mod.
The mouse mod is in the case.
http://i133.photobucket.com/albums/q...SC01806-27.jpg
The shining of the mouse and the connector in the dark ( sorry for the quality of the photos because the camera has problems with focus in the dark)
http://i133.photobucket.com/albums/q...SC01761-26.jpg
http://i133.photobucket.com/albums/q...SC01777-26.jpg
http://i133.photobucket.com/albums/q...SC01784-26.jpg
The hand is on the mouse.
How to make the case for the mouse mod.Everything is rather easy.
You need
http://i133.photobucket.com/albums/q...SC01596-21.jpg
Then you need to buy some special plastic for mounting works.
http://i133.photobucket.com/albums/q...SC01605-21.jpg
The case is covered by plastic. It takes me ages to fit the plastic to the case. Then you cut out the handles and the legs.
After that you cut the microporus (soft) rubber according to the shape of the mouse mod.
http://i133.photobucket.com/albums/q...SC01628-23.jpg
Then you make the shape from the mouse pad ( they are soft and made of cloth)
Then you cover it with velvet.
After that you fix the new handle with stresses to the case.
Then you change the legs.
http://i133.photobucket.com/albums/q...SC01734-34.jpg
Now you have the result.