I noticed you don't list a DVD drive or Blu-ray drive in that list, are you planning on adding one? Also, you're okay with having the radiator for the Antec 620 outside the case because it more than likely will not fit inside. How comfortable are you with cutting the plastic and also with soldering (if you need to make your own USB ports).
hello thanks for u respond,
for the DVD driver, to add it on the dreamcast, it will not be easy, so
but i have one :
and i m looking how to add it with dreamcast.
but for the moment i m looking how to add the motherboard on the dreamcast ?
I m not very comfortable with cutting the plastic, but i really want to do it.
and the project on my other post, i don't understand how the cutting the dreamcast he is so clean.
i really think this guys is good.
For the radiator for the Antec 620, i will fix it on the down of the dreamcast like this :
Cutting the case is not hard. Mark the lines for the cut. Cut inside the lines on the waste side about 5mm away. Use a small file to remove the remaining material. Go slow and take your time.
Can you show what the circuit board and front switch looks like on your DVD drive? There is a limit switch and the front switch that you will need to interface. You will also need an adapter board for the DVD drive. Yes there will be soldering.
Cutting the case is not hard. Mark the lines for the cut. Cut inside the lines on the waste side about 5mm away. Use a small file to remove the remaining material. Go slow and take your time.
Can you show what the circuit board and front switch looks like on your DVD drive? There is a limit switch and the front switch that you will need to interface. You will also need an adapter board for the DVD drive. Yes there will be soldering.
BTW, the first guy that you linked is good; this guy is amazing.
it's very good, how he have modeling the dreamcast case the motherboard and other things and create a virtuel dreamcast pc case.
it's just incredible !!