How do you Remove pins from the female side of a 24 pin extension?
I tried the molex tool pictured, nothing.
How do you Remove pins from the female side of a 24 pin extension?
I tried the molex tool pictured, nothing.
Not dead yet
Should be the same as Male, just less room to get to them.
I tried that, I slid my tool in and there's TONS of room... AKA pins weren't compressed.
and ikik, thats what she said, calm down.
Not dead yet
"The very existence of flamethrowers proves that sometime, somewhere, someone said to themselves, 'You know, I want to set those people over there on fire, but I’m just not close enough to get the job done.” -George Carlin
“Fighting for peace is like screwing for virginity.” -George Carlin
Originally Posted by DynamoNED
Bump? Here's a pic if it helps.
Not dead yet
You need a different tool then. My molex tool works fine.
after more shoving the tool slid in to a recessed notch and the pin popped out.
Not dead yet
i use jewlers needle nose pliers.
hard pressed to find a grabbing tool that's slimmer then it.