My mind says Technic, but my body says Duplo.
Well this is now a moot point. I killed the accelerometer on accident.
Charles (CJ) Gantt: Coil Gun // Biohazard // Circuits // 3D Printer // CoD MW2 Case // TBCS 4GHz Club
Sites: The Makers WorkBench // CJ Gantt Photography
D'oh!
Arctic Cat * Maximum Security * Cribbage Board * Rockin Case * Armor Redux
Tempest SXR * Power House * Red Comet * ICHIWZ * Acrylic Headphone Hook
Continuing sponsorship support from PCBoard.ca
Current Projects: Lobo | Unimatrix | High Voltage | Antec 900 Revamp (Phase 2)
Completed Projects: General Lee | Synergy Green | Liquid Yellow
Planned Projects: K-9-PC | Limey
heh... how was I supposed to know that it was 3v only when the data sheet I got with it said 3-5v operating range....... I did not see any white smoke though, just no output from it now.
Charles (CJ) Gantt: Coil Gun // Biohazard // Circuits // 3D Printer // CoD MW2 Case // TBCS 4GHz Club
Sites: The Makers WorkBench // CJ Gantt Photography
So now the question is "What to do with a broken accelerometer?"
My mind says Technic, but my body says Duplo.
Well its smaller than a 5mm LED but the breakout board its on is about 3/4 the size of a quarter. I may order a new accelerometer from digi key and try my hand at fine pinch hand soldering. Might be the excuse I need to buy a hot air rework station!
Charles (CJ) Gantt: Coil Gun // Biohazard // Circuits // 3D Printer // CoD MW2 Case // TBCS 4GHz Club
Sites: The Makers WorkBench // CJ Gantt Photography
My mind says Technic, but my body says Duplo.
Want another one cheap?
Hehe, I only trust documentation of the manufacturer of the IC. Did you order those level logic converters I showed you?