bench table!!

[blaze15301]

Somethin's wrong here...

please do tell. im very curious.

[blueonblack]

Somethin's wrong here...

I agree.... like the fact that we got this:

did a huge update if anyone is interested.

But *no update*, you big tease!

[blaze15301]

I agree.... like the fact that we got this:




But *no update*, you big tease!

oh i thought that might have been the issue. i deleted my other post and put up the new pictures. the last i tried it it got all messed up. that is the new update inside the old update lol.

[blaze15301]

update

I have gotten a good bit done the past few days. I have remade the hdd cages,cut the acrylic, and I got some more mdf board and cut out the center pieces. I am not going to get the colored acrylic instead I am going to figure a way to wire leds to the clear acrylic to give it a green glow.

Things i have to do.

• Paint

• Nail it together

• Cut the cable management holes

• Sand the edges

• Wire the LEDs.

The comparison of the old hdd cut compared to the new one. The old on is on the left.

Front view of the bottom together and half the center.

As you can see the acrylic is longer then i intended. I am going to have someone at lowes cut out exact pieces.

The front with the radiator hole cut.

The back with the bottom radiator hole cut. the center piece will hold the pump and power supply.

That is all I have for you guys so far. I will hopefully have this completed by June.As always comments and suggestions are welcome.

[Fuganater]

Go-Go-Gadget Necro Thread!

What ever happened to this?

[blaze15301]

I started working on my car then lost interest.

[Fuganater]

aww. this would have been sweet to se finished