Compression Fitting help

[hicks]

I have been looking for a 90degree 1/2" to 3/8" compression fitting for my water cooling system. If there is no such thing can anyone send me a link to a 1/2" 90degree fitting. I am needing it for my pump. And I found this: G1/4 Thread 90-Degree Rotary 1/2" ID x 3/4" OD Compression Fitting from this website: http://www.frozencpu.com/products/10...l=g30c409s1033

But i need both sides to be 1/2"

[mDust]

I have been looking for a 90degree 1/2" to 3/8" compression fitting for my water cooling system. If there is no such thing can anyone send me a link to a 1/2" 90degree fitting. I am needing it for my pump. And I found this: G1/4 Thread 90-Degree Rotary 1/2" ID x 3/4" OD Compression Fitting from this website: http://www.frozencpu.com/products/10...l=g30c409s1033

But i need both sides to be 1/2"

G1/4 or G3/8 are the standard thread size for PC water-cooling fittings. You won't find G1/2 connections on a PC component website...or on any PC pumps for that matter.
Did you perhaps want 1/2" tube fittings on each end, so it connects to tubing at both ends? You can try here and see if those work.
If not, there are straight through fittings that change sizes, here.

[x88x]

So, what exactly are you looking for? It sounds kinda like you want a 90-degree fitting, with 1/2ID 3/8OD compression fittings on both ends. Is that right?

[mDust]

...with 1/2ID 3/8OD...

Might as well be hunting for BigFoot since 3/8 is smaller than 1/2!

[x88x]

Might as well be hunting for BigFoot since 3/8 is smaller than 1/2!

Doh! Sorry, meant 1/2ID 3/4OD