Anyone have an Antec 300 that can test if the premodded cooler master side panel has a good fit on the case? Specs didn't show up on newegg site.
Anyone have an Antec 300 that can test if the premodded cooler master side panel has a good fit on the case? Specs didn't show up on newegg site.
water-cooled m-atx: (sold)
http://www.thebestcasescenario.com/f...ad.php?t=15368
Diary Of a Caffeine Junkie: Powered by Rockstar (dead)
http://www.thebestcasescenario.com/f...ad.php?t=13786
Better yet, maybe just a template of the side window. the fan on my stock panel is about in the right spot.
water-cooled m-atx: (sold)
http://www.thebestcasescenario.com/f...ad.php?t=15368
Diary Of a Caffeine Junkie: Powered by Rockstar (dead)
http://www.thebestcasescenario.com/f...ad.php?t=13786
The dimensions of the 690 lead me to believe the side panel is too big when eyeballing the full dimensions minus the fascia.
Also the 300 doesn't use a standard sliding panel while the 690 looks like it does with those tabs on the end of the panel. The 300 has a metal U channel that hinges on the chassis that swings out 50-60 degrees, then is held in by the screws. You don't slide it in, you put it on at an angle then just drop/set it down.
EDIT: You should be able to fit a similar shaped window on the 300 though. You would just have to do it yourself. Here's a quick window I did for my little brother's 300 a while back.
Not my picture, the brother's. Don't have another.
Just round out the edges and draw the angle out more.