Hmm... Ok here is what I got... Several cut pieces of rent-a-bond.. and an idea.. problem is, what ist he best way to hold the two pieces of rent-a-bond together.. I am bad about moving my comp around and so I dont want to it to be fragile.. the rent-a-bond is strong... if you dont konw what it is: thin piece of plexiglass with an even thinner piece of aluminum on either side.. I am unable to weld aluminum.. Just not that good with a wire welder... Its only about an 1/8 of an inch think so waht is that 0.32 cm think? 3.2mm? somethign like that.. my math sucks.. especially in my head.. I have some angle aluminum but i can only get it with usual 90 degree bendd.. guess i could undo some of that and open it up to about 130 but then it probably wont be even.. and probably not even possible.. I could cut out a bit of the aluminum on one side and bend it to make a frame on the end, but that leaves me with an ugly cut in the frame.. could cover that with bondo but not sure if i wantt o do that and that defeats teh purpose of using the aluminum in the beginning and so I lose that aluminum modern look..
So that is the idea ive thought of... but obviously not the route I am taking.. would silicone bead work to hold it together? And just do angle cuts and but the pieces of angle aluminum together? Hmm... That might work.. but I am not srue of the strength of silicone bead?
Thanks guys.. for even reading that babble at the top.. if you didnt read it.. then SHAME ON YOU! hahah Just kidding...Or am I?