What program did you use to design that circuit?
-Dave
What program did you use to design that circuit?
-Dave
Originally Posted by jdbnsnOriginally Posted by jdbnsn
Eagle 5.6 from cadsoft by the look of it - available as a lite version - freeware with limitations etc - download here - http://www.cadsoft.de/freeware.htm
Current Projects: Lobo | Unimatrix | High Voltage | Antec 900 Revamp (Phase 2)
Completed Projects: General Lee | Synergy Green | Liquid Yellow
Planned Projects: K-9-PC | Limey
Slave has it right! I don't know how I know the name, but I found it because I somehow knew and found they had a freeware version with limitations. So I've been using that ever since, good program too.
After finally getting new speed controllers, we tested the fan on the motor.... They're AMAZING! Infact, when I didn't properly tighten the prop adapter, at about 50-60% power, it flew up and hit the ceiling (luckily noone was hurt because we got people to stay back and the prop was fine too) but once we tightened it all up, we had no problems and we got to 80% before we shut down the system). Pictures and Videos will come later in the week.
Enjoy.
Looking good crenn. Keep up the good work.
Charles (CJ) Gantt: Coil Gun // Biohazard // Circuits // 3D Printer // CoD MW2 Case // TBCS 4GHz Club
Sites: The Makers WorkBench // CJ Gantt Photography
Niiiice. Be fun to see it at 100%
you could probably cut down a small tree @ 100% lol
Considering those are glass filled nylon blades? I don't think we could cut down a tree.