-
duct tape can fix anything
Re: [Project] Modularis Evolution - it begins... updated daily!!
Still looking great, and you're lucky to have a bending rig. I remember using a table, bar, and some clamps to bend steel and it was agony.
-
Re: [Project] Modularis Evolution - it begins... updated daily!!
Thanks guys. yer i bought it when it was on sale down from £80 to £35 so it was a bargain!!!
-
Fresh Paint
Re: [Project] Modularis Evolution - it begins... updated daily!!
lovly mod you have there great work with the plexi +rep
-
-
-
Re: [Project] Modularis Evolution - it begins... updated daily!!
LOLOL!!! umm i guess you could doo as long as you dont mean it in a derogatory way! hahaha
Josh
-
Re: [Project] Modularis Evolution - it begins... updated daily!!
ok guys on with the next update....
I started off the day by cutting out the front and back sections of the hdd housing.
Then I marked my third 4'x2' sheet of 1.629mm alu for the metal I needed for the dvd housing.
And bent
I then cut out the top section
I then quickly got to work on the pump/res housing
And that is all for today
Tomorrows plan of action is to cut and bend the rad housing and then cut the ends for the dvd, pump/res and the rad housings.
Hope you enjoyed this update
Josh
-
Re: [Project] Modularis Evolution - it begins... updated daily!!
intence... you aint waisting your time ill give you that lol, looking foreward for next update
-
Re: [Project] Modularis Evolution - it begins... updated daily!!
Nope if i waste time i will just get too bored i need to do everything now...
thanks for the comment.
josh
-
Re: [Project] Modularis Evolution - it begins... updated daily!!
hey guys,
Time for another update. unfortunately its alot smallre as i have been with my girlfriend more today.
but i did get this done :
I started by cutting the lst side panel for the pump/res housing (excuse the wonkyness i just plonked it on for the photo.)
i then got the alu cut out for the two parts of the rad housing.
and got the first part bent
and that is it for today.
more tomorrow though (hopefully quite a bit more!)
tomorrows plan:
bend the second section for the rad housing
cut out the ends for rad,pump/res,cd/dvd
Then after that is done i will lay it out how it will be (without the supports) to show you guys just how big this beast will be!
then it is onto the acrylic work!
Josh
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules