well my water cooling stuff finally got here!
i spent about 6-8 hours setting it all up i got it working to the point where i turned the computer on. i wanted to see what kind of temps i could expect and sure enough i went down about 10-15 C down on load. i shut down and started doing a leak test, i pulled the plug on my computer and used a spare psu i built for testing things and left it running over night. i put paper towel around the computer and fittings so i could see any leaks the next morning. so i get up and what do i see, water all over my desk, ****!, after looking around i see there is only 1 hose going to the rad and the barb is gone! the dam thing snapped. i believe i tightened them to much so this time around i put them on less tight ( i took the barb from my fill port)
i am still doing leak tests so i am going to shut down and test for the next hour or more and then shut off the pump when i go to bed i don 't need any more problems. so with that here are some pictures that i have taken so far. i will get more once i decide on how i want the setup to look like. i plan to order some more barbs and more tubing should i want to change anything, i think i have about 6-7 feet in the loop.
Rad with 6 fans and fan grills
broken barb
setup thus far
What i ordered.
here is a screen shot of p95 running for 10 minutes
i will post more later on like i said so what do ya think so far?