-
Hp Res 3 Mega (update)
Hi guys :) Ive lurked here for a lil while and im totally impressed by the qual of thr mods here :)
ive just posted my last finished case "HPRes II" over in the project galleries.
This is HP Res III Mega, im trying to take what i did with HPR2 a few steps further.
most of the mods on this case will revolve around bondo work to the case.
once again the whole job will be finished in 2pack auto and have my signature side mounted water tank/s :)
I'm still not 100% on what the end outcome will be or how soon i can finish this mod, but will be fun to share it here with you guys :)
the original case
Making thr MEGA blowhole
New filler panel and adding some bondo
alota sanding :)
a lot more sanding!
More bondo and more sanding!!!!!
some final work and a lota high fill :)
( 2 weeks later!)
A dust coat and final wetub
One MEGA blow hole :)
more to come :)
-
Re: Hp Res 3 Mega
-
Re: Hp Res 3 Mega
r u an hp modding employee promoting the capabilities of their cases in the community? :D excellent job on the blowhole.
-
Re: Hp Res 3 Mega
Excellent - this to me is modding - getting great and imaginative ideas to fruition...........just don't know where you find the time.
Keeping it coming as the final result looked awesome...............
-
Re: Hp Res 3 Mega
very nice. only question i have is, "how are you gonna access the drives." guess im just gonna have to stay tuned.
-
Re: Hp Res 3 Mega
see up the top in the first pic... how its a door...
he just extended that up to be full size, instead of 1 bay to short.
-
Re: Hp Res 3 Mega
Just don't drop that bezel :D
The only thing I hate about bondo is how easy it breaks :(
-
Re: Hp Res 3 Mega
that looks nice man good job so far
-
Re: Hp Res 3 Mega
thanx guys :) a bit more work done, this time to the MB side panel,
again HPR3 will have a side mounted res, the side pansl is modded to suit the theme :)
I've cut some strip of plex these can be bent to shape for the edges.
using a bit of heat the strips of plex bend to shap with little effort.
not too hard.
ive decided to "groove" tenches around the walls, this will give a lower area for the bondo to bite down and sand back level.
a qik re-sand on the groved areas
same with the back
next is to sit the side walls back in and use some hot glue to hold it all in place.
Next is a qik "fitup" test, i a big fan of the fitup test :)
all fits good :)
-
Re: Hp Res 3 Mega
after the initial sand back i could see on the bottem edge of the side hole the bondo wasnt sticking :(
i didnt prep clean proper...... a few holes to act as "anchor points" will fix that.
and some fresh bondo
Some more sanding, using an old peice of plastic pipe i can wrap some 60G around it and sand the shape needed.
Starting to take shape :)